Finishing Material Requirements - Heat & Glo CERONA-36 Owner's Manual

WARNING
Risk of Fire
• Non-combustible clearances must be
maintained.
• Sheetrock, wood or other combustibles must NOT
be used as sheathing or facing in the
non-combustible zone.
• See Section 11 for proper clearances.
• See Section 1 for combustible/non-
combustible definitions.
C. Finishing Material Options
Finishing Material Thickness from 3/4 in. to 1-1/4 in.
Finishing material within this thickness range can be brought
to 1/2 inch behind the door top and sides. These non-com-
bustible finishing materials must never overlap or obstruct
the air outlet/inlet grille areas.
NON-COMBUSTIBLE FINISHING MATERIAL
(INSTALLED OVER NON-COMBUSTIBLE
HEADER
1 IN.
(25mm)
Cerona-36
Cerona-42
Non-combustible facing material is supplied with this appliance.
This material extends from the header to one inch above the
appliance bottom and from framing stud to framing stud.
Figure 11.4
FACING MATERIAL)
B
A
A B
in. 43-5/8 50-3/16
mm 1108 1275
in. 50-5/8 54-3/8
mm 1286 1381
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. A • 6/06
IMPORTANT INSTALLATION NOTE
Please note that there are four holes or dots on the
template to assist in positioning the template. These
holes or dots should line up with the door mounting
holes on the unit to ensure proper placement of the
door after finishing materials are installed.
Finishing Material Thickness greater than 1-1/4 inch
A steel template (Cerona-36 Template or Cerona-42 Tem-
plate) is available for purchase to use instead of construct-
ing a template.
A
B
C
D
A
in. 34-1/2 23-9/16 5-3/16 1-1/4
Cerona-36
mm 876
in. 38-7/8 25-1/4
Cerona-42
mm 987
F
in. 1-1/4 28-13/16
Cerona-36
mm 32
in. 2-5/8 31-7/16
Cerona-42
mm 67
Figure 11.5 Facing Template Dimensions
Mounting stone eye brow: ATRIMSTONE-36,
NOTE: When mounting ATRIMSTONE-36 OR
ATRIMSTONE-42 you must install template or front
to insure proper positioning. Failure to do so will
result in the front not fitting (see Figure 11.5).
R I
Ø H
G
E
B C D E
38
598 132 32 965
3-5/8 2-5/8 46-1/4
641 92 67 1175
G H I
3/8 34-5/8
732 10 879
3/8 39-5/8
799 10 1006
ATRIMSTONE-42
F
35