Finishing Material - Heat & Glo ST-36TR-IPI Owner's Manual

D. Finishing Material
Only decorative fronts certifi ed for use with this appli-
ance model may be used. Contact your dealer for a list
of decorative fronts that may be used. Once you have
determined what kind of decorative front and fi nishing
material is going to be used on the fi replace, you may use
the table below which shows the decorative front models
and the fi nishing material thickness allowed. For an inside
fi t there is an available template to assist with sizing the
fi nishing material.
ST-36TR-IPI
DECORATIVE
FIT
FRONT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Galleria
Inside
PIER-36TR-IPI
DECORATIVE FRONT FIT
Folio Inside
Chateau Inside
Arcadia Inside

FINISHING MATERIAL

Stop fi nishing material fl ush with opening.
Figure 13.18 Folio Decorative Front
FRONT FACE OF FIREPLACE
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 13.19 Overlap Fit Decorative Front
60
FINISH MATERIAL
SEE
MAXIMUM
FIGURE
THICKNESS
Any 13.18
1 inch 13.19
Any 13.20
1 inch 13.19
Any 13.21
1 inch 13.19
Any 13.20
1 inch 13.19
Any 13.21
FINISH MATERIAL
SEE
MAXIMUM
FIGURE
THICKNESS
Any 13.22
Any 13.22
Any 13.22
DOOR
FINISHING MATERIAL
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. L • 4/15
FINISHING
MATERIAL
DOOR
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
33-3/4 in.
(Inside door height)
37 in.
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
Finishing materials over 1 inch thick.
Figure 13.20 Inside Fit Decorative Front
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
DOORS
37-1/4 IN.
Finishing material between 1 and 2 inches thick.
Figure 13.21 Operable Hinge Decorative Front
FINISHING
MATERIAL
37 in.
34 in.
FINISHING
MATERIAL