Appliance Preparation; Removing Non-Combustible Facing Material Assembly - Heat & Glo CERONA-36 Owner's Manual

7

Appliance Preparation

A. Removing Non-combustible Facing
Material Assembly
The non-combustible assembly is located on the back of
appliance (see Figure 7.1).
Remove screws
from upper
bracket.
Figure 7.1 Non-Combustible Facing Material Assembly
20
L o w e r
Bracket
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. A • 6/06
CAUTION
Handle with care.
• Non-combustible material may be damaged if dropped.
• Hold non-combustible pieces in place.
• Remove and save two screws from upper brackets (see
Figure 7.1).
• Remove non-combustible pieces.
• Remove and save three screws from lower bracket (see
Figure 7.1).
• Discard brackets.
• Replace screws in holes where these pieces were at-
tached to appliance.