Appliance Preparation; Top Vent - Heat & Glo 350TRSI-AUF Owner's Manual

9

Appliance Preparation

A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
2 SCREWS
Figure 9.1 For top vent, remove the two screws holding
the top heat shield in place. For rear vent, see Section 9.B.
WARNING! Risk of Fire! Do not remove heat shield. El-
evated header temperatures may cause a fire.
Figure 9.2 Rotate the top heat shield to the vertical
position as shown above. The heat shield must remain in
the vertical position.
2 SCREWS
Figure 9.3 Replace the two screws as shown.
Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. o • 6/12
Note: Actual unit may look different than the fireplace shown
in this section.
Figure 9.4 Remove the seal cap.
Figure 9.5 Remove the insulation basket and white insula-
tion from the center vent pipe.
Figure 9.6 Remove the insulation from the outer vent pipe.
41