User Security Codes - Honeywell ADEMCO VISTA-10P Installation And Setup Manual

Installation Instructions

User Security Codes

The system supports up to 16 security codes, which can each be assigned one of 4 authority levels.
The authority level determines the functions each code can perform as follows:
Authority Levels
(authority levels can be assigned to users 3-16 only; users 1 and 2 cannot be changed)
Level User No.
Installer 01
System 02
Master
0-User 03-16
1-Arm Only see "user"
2-Guest see "user"
3-Duress see "user"
Refer to the user guide for procedures on adding/deleting security codes and changing attributes.
The following is a brief description of how to add user codes.
Changing the System Master code...
Using Installer code: Installer code + [8] + 02 + new code
Using current System Master code: System Master code + [8] + 02 + new code + new code again
Adding a User Code:
Deleting a User Code: Master code + [8] + 2-digit user no. + [#] [0]
Assigning Attributes: Master code + [8] + 2-digit user no. + [#] [attribute no.] + value
Attributes:
1 = Authority Level 0-3 (see Authority Level table above)
2 = Access Group 0-8 (0 = not assigned to a group)
3 = Not Used
4 = RF Zone No.;assigns user number to button type zone (keyfob) for arm/disarm.
(keyfob must be enrolled in system first; see Wireless Key Templates section)
5 = Open/Close Paging; 1 for yes, 0 for no
Setting the Real-Time Clock
1. +[#] + [6] [3]
(Security Code)
2. Press [∗] when the time/date is displayed.
A cursor appears under the first digit of the hour.
To move cursor ahead, press [
• Enter the 2-digit hour and 2-digit minute setting.
• Press [1] for PM or [2] for AM.
• Enter the last two digits of the current year.
• Enter the 2-digit month and 2-digit day setting.
3. To exit, press [∗] when cursor is at the last digit, or
wait 10 seconds.
6-4
Functions
(default=4112) perform all security functions except can disarm only if used to
arm; can enter program mode; can change System Master code; cannot assign any
other user codes
(default 1234) only one system master code per system; can perform all
security functions, add/delete users, change system master code, view event log, set
system clock, program keypad macro, program scheduled events, activate output
devices (triggers/relays)
perform security functions (arm, disarm, etc.) only; cannot add/delete
users, view event log, set system clock or program scheduled events
arm system only
can disarm the system only if it was used to arm the system
performs security functions, but also silently sends a duress message to the central
station; reports as duress code user number.
Master code + [8] + 2-digit user no. + user's code
Values
∗
]. To go back, press [#].
Alpha Display:
DISARMED
READY TO ARM
TIME/DATE SAT
04:04PM 10/17/00
Current time display
TIME/DATE SAT
04:04P2000/10/17
Time/date editing display