Installation Instructions - Honeywell ADEMCO VISTA-10P Installation And Setup Manual

Installation Instructions

Table of Device Addresses
This Device
RF Receiver
Long Range Radio
4286 Voice Module
4204 Relay Module
Keypads:
keypad 1
keypad 2
keypad 3
keypad 4
keypad 5
keypad 6
keypad 7
keypad 8
5800TM Module
††
Addressable devices are identified by "1" plus the device address when reporting. Enter a report code for zone 91 to enable
addressable device reporting (default = reports enabled). See field *199 for addressable device (ECP) 3-digit/2-digit
identification keypad display options.
3-6
††
Uses Address Reports as
00 100
03 103
04 104
12 112
16 n/a
17 n/a
18 n/a
19 n/a
20 n/a
21 n/a
22 n/a
23 n/a
28 n/a
Enabled By...
*56 zone programming: input device type entry
automatic if output to long range radio field *29 enabled
automatic if phone module access code field *28 enabled
*79 output device programming: entered at device address prompt:
data field programming as listed below:
always enabled, all sounds enabled.
data field *190
data field *191
data field *192
data field *193
data field *194
data field *195
data field *196
automatic