Insulating Spacer X; Toothed Pan Washer X; Pan Head Bolt With Hex Socket (M8-45) X - Panasonic TY-ST42PT3S Installation Manual

Ceiling unit
Ceiling unit
Pan head bolt with hex socket
(M8-45) x 4

Toothed pan washer x 4

Speakers
Speaker x 2
Points to note during installation
•
This ceiling unit is for mounting a Wide Plasma Display to a ceiling for viewing pur poses.
Do not use it for any type of installation other than ceiling mounting.
•
In order to ensure correct, problem-free operation of the Wide Plasma Display, do not install the Display in any of
the following places:
• Next to sprinklers or sensors
• Where it may be subject to vibration or shocks
• Near high-voltage wires or electric motors
• Where it may be in direct contact with air from heaters
•
When installing this ceiling unit, use a fixing method appropriate to the type of ceiling.
•
Insert the mains plug for the Wide Plasma Display into a mains socket which is close and easily accessible.
•
Provide adequate ventilation so that the temperature around the display does not rise above 40°C (104 F°).
If there is insufficient movement of the air inside the display, heat may build up inside the display and fire may result.
•
For U.S.A (TH-42PW3 / TH-42PWD3 only)
If the connection cable cannot reach the Display when it has been installed to the wall, use the 15 m cable (TY-
SCP15C03) which is sold separately.

Insulating spacer x 4

Allen key
Fixing bolt (M8-100)
Spring washer
Washer pan nut (M8)
Mounting bracket
(right) x 2
Mounting bracket
(left) x 2
Fixing bolt (M8-12) x 2
Fixing screw (M5) x 2
Fixing bolt (M8-20) x 2
Cable tie x 2
Bracket mounting
Assembly screw (M4-10) x 12
Sponge x 2
Speaker cable
(20 cm) x 2