Instruction Of The Installation; Fixing The Wall-Hanging Bracket To The Wall - Panasonic TY-ST42PT3S Installation Manual

Instruction of the installation

Fixing the wall-hanging bracket to the wall

1
Check the strength of the installation location
The wall-hanging bracket weighs approximately 6kg, and the display unit by
itself weighs 33kg. Refer to the wall-hanging bracket installation dimensions
in the diagram below to, check the strength of the wall in six installation locations,
and add reinforcement if any of these locations are not strong enough.
1) Select an installation site with an area of at least 1,500 mm wide by
800 mm high. Refer to the figure to make a positioning mark for the
location of the center-top hole.
2) Measure and mark the locations 450 mm to the left and 450 mm
horizontally to the right of the location you marked in 1).
3) Measure and mark the locations 450 mm below each of the marked
location.
Units : mm
Used for routing wires behind a wall
15
4-
4
930
450
100 50
Wall installation holes(6 locations)
15
450
The wall-hanging bracket
has installation holes
provided at 24 locations.
If the wall material does
n o t a l l o w s u f f i c i e n t
strength by using six
installation holes, use
s o m e o f t h e s p a r e
holes.
However, depending on
t h e c o n s t r u c t i o n
material used at the
place of installation,
cracks may develop if
the screws are inserted
too close to each other.