Fixing The Insulating Spacers To The Display Unit - Panasonic TY-ST42PT3S Installation Manual

2
Insert and fasten a M6 screw bolt into the center-top hole.
3
Use a level gauge to correct the alignment of the wall-hanging bracket,
and screw bolts into the remaining five holes.
4
Provisionally tighten the fixing screws.
Fixing the insulating spacers to the display
unit
1
Spread a clean cloth over a level floor or base, and place on it the display
unit face down.
Remove the four screws from the display.
2
Use the accessory tool "Allen key" to install the four accessory
and into the holes.
If required, use commer-
c i a l l y a va i l a b l e M 6
bolts which suit the wall
materials.
If the Screws protrude
more than 5 mm, it will
not be possible to install
the Wide Plasma Display
in the correct position.
Place the display unit
face down on top of a
cloth clean and free from
otherforegin particles,
,
and then proceed to the
next step.
Pan head bolt with
hex socket
Toothed pan washer
Insulating spacer
4-
5