Connect The Speaker Cables - Panasonic TY-ST42PT3S Installation Manual

Connect the speaker cables.

• After preparing the ends of the speaker cables, connect them as shown.
• Connect the speaker cable for the left speaker in the same way.
• The red cable is for the (+) side and the black cable is for the (-) side. Do not
connect the cables to the wrong sides.
Preparing the ends of the
speaker cables
1. Press down on the lever.
2. Insert
the cable.
3. Release the lever.
When these speakers are attached to the plasma display, they will not
form a straight line but rather so that they slightly face inward, to produce
stable sounds.
1. If connecting to an external amplifier which exceeds the rated input for the speakers, lower the
amplifier volume to protect the speakers from damage. If any problems occur with speaker operation,
disconnect the mains lead of the amplifier and consult a qualified service technician.
2. Do not place the speakers in the following places:
• Places which are exposed to direct sunlight
• Near heaters or other heat sources
• Places with high humidity
3. This set is equipped with magnetic resistant speakers but be careful not to place them near the
CRT TV as it may cause color patches.
4. To clean the speakers, wipe them with a soft cloth. If they are extremely dirty, wipe them with a
cloth which has been soaked in a small amount of household detergent, and then wipe the dry
with a separate cloth.
• Do not use solvents such as alcohol or thinner.
• If using chemically-treated cloths, follow the instructions on the cloth packaging.
5. Remove the dust on the speaker net using a duster or a vacuum cleaner at low power. Since the
net is made of cloth, pushing too hard on it may damage the net.
While twisting
1. Push down the lever.
2. Insert
the cable.
3. Return the lever to its
normal position.
Speaker cable
(20 cm) x 2
7-
5