Making Coffee Using Pre-Ground Coffee; Making Drinks With Milk; Filling And Attaching The Milk Container; Making Cappuccino - DeLonghi Perfecta ESAM5600 User Manual

NB!
• While the machine is making coffee, delivery
can be interrupted at any moment by pressing
the lit cup icon.
• At the end of delivery, to increase the quantity
of coffee in the cup, just press (within 3
seconds) one of the coffee icons (
Once the coffee has been made, the appliance is
ready to use again.
NB: Tips
For hotter coffee, you should:
1) perform a rinse cycle as described in the sec-
tion "Manual rinsing".
2) before making coffee, warm the cups by rin-
sing them with hot water (using the hot water
function).
Important! If the coffee is delivered a drop
at a time, too fast and not creamy enough or too
cold, read the tips in the "Troubleshooting" section
on page 24.
Making coffee using pre-ground
coffee
Important!
• Never add pre-ground coffee when the coffee
maker is turned off or it could spread through
the inside of the appliance and dirty it. This
could damage the appliance.
• Never use more than 1 level
measure or it could dirty the
inside of the coffee maker or
block the funnel.
NB! If you are using pre-ground coffee, we
recommend you make just one cup of coffee at a
time.
1. Repeatedly press the selection icon (C4) cor-
responding to the "taste" bar until "Ground
-
taste" and
display.
2. Put one level measure of pre-ground coffee
into the funnel (fig. 14).
3. Place a cup under the coffee spouts.
4. Press the 1 cup coffee icon
selected quantity and "Ground taste" are dis-
played.
5. Preparation begins. A cup appears on the dis-
play and gradually fills as preparation pro-
gresses.
or
are displayed on the
+
(fig. 12). The
NB:
While the machine is making coffee, delivery can
be interrupted at any moment by pressing the lit
cup icon.
Once the coffee has been made, the appliance is
ready to use again.
).
NB: See the tips in the section above.
MAKING DRINKS WITH
MILK
Filling and attaching the milk
container
1. Turn the lid of the milk container clockwise
until it becomes noticeably difficult to turn,
then remove (fig. 15).
2. Fill the milk container with a sufficient quan-
tity of milk, not exceeding the MAX level mar-
ked on the handle (fig. 16).
NB! Do not use full fat milk. Use skimmed
or semi-skimmed milk at refrigerator temperature
(about 5°C). To avoid milk with poor froth or large
bubbles, always clean the milk container lid and
hot water nozzle as described in the section
"Cleaning the milk container".
3. Make sure the milk intake tube is correctly
inserted in the bottom of the milk container lid
(fig. 17).
4. Replace the milk container lid and turn anti-
clockwise as far as it will go.
5. Remove the hot water spout from the nozzle
(fig. 18).
6. Attach the container to the nozzle, pushing as
far as it will go (fig. 19).
7. Place a sufficiently large cup under the coffee
spouts (A14) and the milk spout (B5). If
necessary, move the milk spout slightly out-
wards (fig. 20).
8. To use particularly tall cups/glasses, raise the
lid of the special compartment in the cup tray
(fig. 21).

Making cappuccino

1. After attaching the milk container (see the
section: "Filling and attaching the milk contai-
ner"), position the frothed milk regulator on
CAPPUCCINO (fig. 22). The quality of froth
can be adjusted during delivery by moving
the regulator slightly towards LATTE for a
15