Manual Configuration; Dynamic (Cable) - D-Link DIR-615 User Manual

Section 3 - Coniguration
If you opt to set up your Internet connection manually, you will be redirected to a WAN page that allows you to select your
Internet type and enter the correct configuration parameters.
Select your Internet connection type using the "My Internet Connection is" drop-
down menu.
At any stage, you can click on the Save Settings button to accept the changes
made, or click on the Don't Save Settings button to discard the changes made.
My Internet
Select Dynamic IP (DHCP) to obtain IP address information automatically
Connection:
from your ISP. Select this option if your ISP does not give you any IP numbers
to use. This option is commonly used for cable modem services.
Host Name:
The host name is optional but may be required by some ISPs. Leave blank
if you are not sure.
Use
Check the box if you are having problems obtaining an IP address from
Unicasting:
your ISP.
Primary/
Enter the primary and secondary DNS server IP addresses assigned by your
Secondary
ISP. These addresses are usually obtained automatically from your ISP. Leave
DNS Server:
at 0.0.0.0 if you did not specifically receive these from your ISP.
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal
performance with your specific ISP. 1500 is the default MTU.
MAC
The default MAC address is set to the Internet port's physical interface MAC
Address:
address on the broadband router. It is not recommended that you change
the default MAC address unless required by your ISP. You can use the Clone
Your PC's MAC Address button to replace the Internet port's MAC address
with the MAC address of your Ethernet card.
D-Link DIR-615 User Manual

Manual Configuration

Dynamic (Cable)

16