Ipv6; Auto Detection - D-Link DIR-615 User Manual

Section 3 - Coniguration
This section allows you to set up an IPv6 connection. There are several connection types to choose from: Auto Detection,
Static IPv6, Autoconfiguration (SLAAC/DHCPv6), PPPoE, IPv6 in IPv4 Tunnel, 6to4, 6rd, and Link-local. If you are unsure of your
connection method, or are missing any of the information required in any of the steps in this section, please contact your IPv6
Internet Service Provider.
At any time during the IPv6 setup, you can click the Save Settings button to save your current configuration, or click the Don't
Save Settings button to discard any changes.
The DIR-615 is able to automatically detect your IPv6 connection type and acquire the relevant settings from your ISP. You
should only populate the other fields on this page if you are familiar with their functions, or you have been instructed to do
so by your ISP.
My IPv6 Select Auto Detection to have the DIR-615 automatically detect your
Connection Is: IPv6 connection. Once selected, you can click Save Settings to save
the configuration. If the auto detection is successful, the Internet LED
on the front of your router will be lit green.
Note: If you have a PPPoE account which only allows an IPv6
connection, you cannot use the auto detection feature and should
select PPPoE and set up the connection manually.
IPv6 DNS Select either Obtain IPv6 DNS Servers Automatically or Use the
Settings: following IPv6 DNS Servers.
Primary/ If you did not choose to obtain DNS servers automatically, enter the
Secondary DNS primary and secondary DNS server addresses.
Address:
Enable DHCP- Check this box to enable DHCP-PD services.
PD:
LAN IPv6 Enter the LAN (local) IPv6 address for the router.
Address:
D-Link DIR-615 User Manual

IPv6

Auto Detection

43