Fuse Replacement; Interlock Connector - Chauvet Scorpion User Manual

3. S
ETUP
AC Power
Fuse
Replacement
Interlock
Connector
Page 10 of 68
This product has an auto-ranging power supply and it can work with an input voltage
range of 100~240 VAC, 50/60 Hz.
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixture's specifications chart. A fixture's listed
current rating indicates its average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
This fixture uses a T 1 A, 250 V fuse. Follow the instructions below to change it in case it
blows.
Disconnect this product from the power outlet before replacing the fuse.
1. Wedge the tip of a flat head screwdriver into the slot of the fuse holder and pry it out
of its housing.
2. Remove the blown fuse from its holder and replace it with a fuse of the exact same
type and rating.
3. Insert the fuse holder back in its place, and reconnect power.
Always replace a blown fuse with a good fuse of the same type and rating.
This product has a jack for a remote interlock switch that would shut off the laser output
in case of emergency. You may use the provided remote interlock connector to build
your own interlock switch.
Scorpion™ GBC EU/RBM EU/RGY EU/BLU EU User Manual (Rev. 5 ML)
The fuse is located inside
this compartment.