Commands - Seagate ST4000VX000 Product Manual

www.seagate.com
4.3.3 S.M.A.R.T. commands
S.M.A.R.T. provides near-term failure prediction for disk drives. When S.M.A.R.T. is enabled, the drive monitors
predetermined drive attributes that are susceptible to degradation over time. If self-monitoring determines that a
failure is likely, S.M.A.R.T. makes a status report available to the host. Not all failures are predictable. S.M.A.R.T.
predictability is limited to the attributes the drive can monitor. For more information on S.M.A.R.T. commands and
implementation, see the Draft ATA-5 Standard.
SeaTools diagnostic software activates a built-in drive self-test (DST S.M.A.R.T. command for D4
unnecessary drive returns. The diagnostic software ships with all new drives and is also available at:
http://seatools.seagate.com.
This drive is shipped with S.M.A.R.T. features enabled.
the drive uses.
Table 9 S.M.A.R.T. commands
Code in features register
D0
H
D2
H
D3
H
D4
H
D5
H
D6
H
D8
H
D9
H
DA
H
If an appropriate code is not written to the Features Register, the command is aborted and 0x 04 (abort)
Note
is written to the Error register.
Seagate Surveillance HDD Product Manual, Rev. A
Table 9
S.M.A.R.T. command
S.M.A.R.T. Read Data
S.M.A.R.T. Enable/Disable Attribute Autosave
S.M.A.R.T. Save Attribute Values
S.M.A.R.T. Execute Off-line Immediate (runs DST)
S.M.A.R.T. Read Log Sector
S.M.A.R.T. Write Log Sector
S.M.A.R.T. Enable Operations
S.M.A.R.T. Disable Operations
S.M.A.R.T. Return Status
below shows the S.M.A.R.T. command codes that
SATA Interface
) that eliminates
H
26