Supported Ata Commands - Seagate BARRACUDA COMPUTE ST6000DMZ03 Product Manual

Notes
1 All pins are in a single row, with a 1.27 mm (0.050 in) pitch.
2
The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
3
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane
configuration.
4
All used voltage pins (V
4.3

Supported ATA Commands

Table 9 lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA commands, refer to the Serial ATA
International Organization: Serial ATA (Revision 2.6). Refer to www.sata-io.org.
Refer to S.M.A.R.T. commands
Table 9 Supported ATA commands
ATA-standard commands names
Device Configuration Restore
Device Configuration Freeze Lock
Device Configuration Identify
Device Configuration Set
Download Microcode
Execute Device Diagnostics
Flush Cache
Flush Cache Extended
Identify Device
Initialize Device Parameters
Read Buffer
Read DMA
Read DMA Extended
Read DMA without Retries
Read Long with Retries
Read Long without Retries
Read Multiple
Read Multiple Extended
Read Native Max Address
Read Native Max Address Extended
Read Sectors
Read Sectors Extended
Read Sectors without Retries
Read Verify Sectors
Seagate BarraCuda Product Manual, Rev. J
) must be terminated.
x
on page 27 for details and subcommands used in the S.M.A.R.T. implementation.
Command code (in hex)
B1h/C0h
B1h/C1h
B1h/C2h
B1h/C3h
92h
90h
E7h
EAh
ECh
91h
E4h
C8h
25h
C9h
22h
23h
C4h
29h
F8h
27h
20h
24h
21h
40h
19