Inspection, Maintenance, And Cleaning - Central Machinery 93507 Assembly And Operating Instructions Manual

automatically lower on its own, while it gradually feeds the Saw Blade (127) into
the workpiece. Do not force the Bandsaw to remove material faster than it is
designed to cut. NOTE: The speed at which the Saw Arm moves downward may
be increased or decreased by adjusting the valve on the Hydraulic Cylinder (20).
(See Figure V.)
14. Never attempt to remove material stuck in the moving parts of the Bandsaw
while it is plugged in and running. Turn off the Bandsaw if the workpiece is to be
backed out of an uncompleted cut.
IMPORTANT: When in the horizontal cutting mode only, the Motor Toggle Switch
15.
(37) will automatically turn to its "OFF" position and shut off the Bandsaw's Mo-
tor when the cut has been completed.
16. Once the cut is made, check to make sure the Motor Toggle Switch (37) is in its
"OFF" position. Turn the Coolant Pump Toggle Switch (11) to its "OFF" position.
Turn the Coolant Pump Valve (159) to its "CLOSED" position. Then, unplug the
Power Cord Plug (38) from its electrical outlet. (See Figure V.)
17. Wait until the Saw Blade (127) comes to a complete stop. Then, raise the Saw
Head to its full vertical position. Turn the Hydraulic Cylinder (20) to its "OFF"
position to lock the Saw Head in place. Remove the workpiece from the Vise as-
sembly (94, 95) and scrap material from the Table (39) of the Bandsaw.
(See Figure V.)
Turn the Hydraulic Cylinder (20) to its "ON" position. Adjust the feed rate if
18.
needed (by turning the knob on the Cylinder counterclockwise), and slowly allow
the Saw Head to lower to its horizontal position. (See Figure V.)

INSPECTION, MAINTENANCE, AND CLEANING

WARNING! Make sure the Motor Toggle Switch (37) and Coolant Toggle Switch
1.
(11) of the Bandsaw is in their "OFF" positions and the tool is unplugged from its
electrical outlet before performing any inspection, maintenance, or cleaning pro-
cedures.
Before each use, inspect the general condition of the Bandsaw. Check for loose
2.
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
For technical questions, please call 1-800-444-3353.
SKU 93507
REV 10/06
Page 24