Central Machinery 93507 Assembly And Operating Instructions Manual page 25

Before each use, inspect the Saw Blade (127). Using a dull Saw Blade will cause
3.
excessive wear on the Motor of the Bandsaw and will not produce a satisfactory cut.
Replace with a new Saw Blade when needed. To replace a Saw Blade:
a. NOTE: Make sure to wear heavy duty work gloves to avoid accidental cuts from
the Saw Blade (127) when performing this procedure.
b. Turn the Hydraulic Cylinder (20) to its "ON" position, and raise the Saw Head
to its full vertical position. Then, turn the Hydraulic Cylinder (20) to its "OFF"
position to lock the Saw Head in place. (See Figure V.)
c. Open the Wheel Cover (129). (See Figure W.)
d. Release Saw Blade (127) tension by turning the Blade Tension Knob (181).
(See Figure W.)
e. Slip the old Saw Blade (127) off the Upper Blade Wheel (175), Lower Blade
Wheel (124), and Guide assemblies. (See Figure W.)
f. Place the new Saw Blade (127) between each of the Guide assemblies and
around the Upper Blade Wheel (175) and Lower Blade Wheel (124).
IMPORTANT: The teeth must be pointing downward toward the Motor.
(See Figure W.)
UPPER BLADE WhEEL
(175)
LOWER BLADE WhEEL
(124)
FIGURE W
For technical questions, please call 1-800-444-3353.
SKU 93507
BLADE TENSION KNOB
(181)
UPPER
GUIDE
ASSY.
LOWER
GUIDE
ASSY.
SAW
WhEEL COVER
BLADE
(129)
(127)
Page 25