Basic Bandsaw Operation -- Horizontal Position - Central Machinery 93507 Assembly And Operating Instructions Manual

10. When cutting a large workpiece, make sure its entire length is properly support-
ed. If necessary, use a roller stand (not included) with a larger workpiece.
11. Allow the Saw Blade (127) to turn up to full speed before feeding the workpiece
into the Saw Blade. (See Figure U.)
WARNING! Always keep hands and fingers safely away from the cutting
12.
area.
13. Feed the workpiece into the Saw Blade (127) gradually. Do not force the Band-
saw to remove material faster than it is designed to cut. (See Figure U.)
14. Never attempt to remove material stuck in the moving parts of the Bandsaw
while it is plugged in and running. Turn off the Bandsaw if the workpiece is to be
backed out of an uncompleted cut.
Once the cut is made, turn the Motor Toggle Switch (37) to its "OFF" position.
15.
Turn the Coolant Pump Toggle Switch (11) to its "OFF" position. Turn the Cool-
ant Pump Valve (159) to its "CLOSED" position. Then, unplug the Power Cord
Plug (38) from its electrical outlet. (See Figure U.)
16. Wait until the Saw Blade (127) comes to a complete stop. Then, remove the
workpiece and scrap material from the Large Vertical Cutting Plate (182).
(See Figure U.)
Turn the Hydraulic Cylinder (20) to its "ON" position. Adjust the feed rate if
17.
needed (by turning the knob on the Cylinder counterclockwise), and slowly allow
the Saw Head to lower to its horizontal position. (See Figure U.)

Basic Bandsaw Operation -- horizontal Position:

WARNING! Always wear ANSI approved safety impact eye goggles when
1.
operating the Bandsaw.
Do not plug the Power Cord Plug (38) into an electrical outlet until all nec-
2.
essary adjustments (as previously discussed in this manual) have been
made. Be sure that the Bandsaw is set up with it's Small Vertical Cutting
Plate (142) before proceeding - see page 17.
Turn the Hydraulic Cylinder (20) to its "ON" position, and raise the Saw Head to
3.
its full vertical position. Then, turn the Hydraulic Cylinder (20) to its "OFF" posi-
tion to lock the Saw Head in place. (See Figure U.)
4. Secure the workpiece in the Vise assembly (94, 95). When cutting a large work-
piece, make sure its entire length is properly supported. If necessary, use a roller
stand (not included) with a larger workpiece. (See Figure V.)
5. If cutting several workpieces at the same length, you may wish to adjust the Stop
Block (73) to the desired position. (See Figure V.)
For technical questions, please call 1-800-444-3353.
SKU 93507
REV 10/06
Page 22