Installing/Removing The Crutch/Cane Holder - Invacare Lynx L-4 Owner's Operator And Maintenance Manual

SECTION 12—ACCESSORIES

Installing/Removing the Crutch/Cane Holder

WARNING
The installation of the crutch/cane holder onto the back of the scooter seat signifi-
cantly increases the length of the scooter. When turning the scooter or swiveling
the scooter seat, it is important to take note of this increased length - otherwise,
injury and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 12.2.
Installing
1. Install the crutch/cane holder into the accessory tube located on the back of the seat.
2. Install the mounting knob to secure the crutch/cane holder in place. Securely tighten.
3. Align the slot on the base with the hook on the crutch/cane holder and slide base down
into position.
Removing
1. Remove the crutch/cane holder from the accessory tube.
2. Remove the mounting knob that secures the crutch/cane holder in place.
3. Remove the crutch/cane holder from the accessory tube.
Crutch Cane
Holder
Mounting Knob
Hook
Base
Accessory Tubes
FIGURE 12.2 Installing/Removing the Crutch/Cane Holder
46
Lynx™L-3 & Lynx L-4 Part No. 1143205