Console Commands - KTI Networks KGD-802 User Manual

2.12.1 Console Commands

Three command sets are provided as follows:
System commands
>System↵
System>Info↵
Name:
S/W Version: x.xx
H/W Version: x.xx
MAC address: xx-xx-xx-xx-xx-xx
System>Restore default↵
System>Restore default keepIP↵
System>Name [<name>]↵
System>Reboot↵
Console commands
>Console↵
Console>Info↵
Password:
Timeout:
Prompt:
Console>Password [<password>]↵
Console>Timeout [<timeout>]↵
Console>Prompt [<string>]↵
IP commands
>IP↵
IP>Info↵
Address: xxx.xxx.xxx.xxx
Subnet Mask: xxx.xxx.xxx.xxx
Gateway: xxx.xxx.xxx.xxx
Dhcp: disabled
IP>Setup [<ipaddress>[<ipmask>[<ipgateway>]]]↵
IP>Status↵
Dynamic Address:xxx.xxx.xxx.xxx Subnet Mask: xxx.xxx.xxx.xxx
Gateway: xxx.xxx.xxx.xxx dhcp Address: xxx.xxx.xxx.xxx
IP>Dhcp [enable / disable]↵
; display system information
; System name of this switch unit
; Software version
; Hardware version
; MAC address of this switch unit
; Restore factory default configuration
; Restore defaults, but keep IP no changed
; Assign a system name to the switch unit
; Reboot the switch unit
; console information
; password for entering into management interface
; timeout for console connection without user action
; current command prompt used
; change password
; change timeout value
; change prompt string
; IP information
; IP address
; Subnet mask
; Gateway IP address
; Gateway IP address
; Setup new IP
; DHCP status when enabled
; Use DHCP mode or not
-22-