Table of Contents
Advertisement
6.2 Management with Console Connection
Please follow the steps to complete the console hardware connection first.
1. Connect from the console port of the switch to COM port of PC with the
console cable.
2. Start the terminal program. Create a new connection and select COM port of
PC used for the console.
[38400,8,N,1]. (With Windows, you can find the terminal program in [Start] ->
[Programs] -> [Accessory Programs] -> [Communication] -> [Terminal]. If you
cannot find it, please install it from your Windows Installation Disk. Please
refer to your Windows user manual for the installation.)
3. Power on the switch.
If everything is correct, the booting screen will appear in the terminal program
when the switch is powered on.
initializing messages.
-------------------------------------------------------------------------------------------------------
Booting Program Version 1.05.00, built at 14:44:03, Jul 29 2005
RAM: 0x00000000-0x00800000, 0x0000cc78-0x007f3000 available
FLASH: 0x05800000 - 0x05900000, 16 blocks of 0x00010000 bytes each.
==> enter ^C to abort booting within 3 seconds ......
Start to run system initialization task
[System Configuration]
Company Name
:
Model Name
: Intelligent Switch
MAC Address
: 00:00:01:23:45:67
Firmware Version : 3.02.02 < Mar 13 2006 15:13:36 >
Press <ENTER> key to start.
UCD-SNMP version 4.1.2
-------------------------------------------------------------------------------------------------------
Press Enter key, user name and password will be requested. The default user
name and password is "admin" / "123456".
After login the switch, a prompt will be shown.
command-line operation for console interface, you can press "?" or "help" to
check the command list first.
Note: Management with Telnet connection has the same interface as console
connection.
Set the configuration of the terminal as
It will stop at the following screen after some
Because this switch supports
10
Advertisement
Table of Contents
