Table of Contents
Advertisement
Enter the following syntax:
4.
B22ENA10 [/IRQ:x][/IOP:xxx]
where:
For example, the following command enables a BayStack 22 network card
having an IRQ value of 5 and an IOP value of 300:
B22ENA10 /IRQ:5 /IOP:300
Note: If you installed the EMM386.EXE program in CONFIG. SYS, you must
exclude the memory address range D000 to DFFF or D400 to D7FF in the
EMM386.EXE program. The B22ENA10.EXE program uses this memory
address range to read configuration information from the BayStack 22 network
card.
For example, the following commands exclude the required memory address
range:
DEVICE=EMM386.EXE NOEMS X=D400-D7FF
DEVICE=EMM386.EXE NOEMS X=D000-DFFF
Access the Novell NetWare client directory on your client laptop.
5.
From the \NETWARE\DOSODI directory on the BayStack 22 PCMCIA
6.
Card Adapter Software & Documentation CD, copy the following files:
LSL.COM
B22ODI10.COM
IPXODI.COM
NETX.EXE
NET.CFG
The STARNET.BAT file in the \NETWARE\DOSODI directory executes the
first four files automatically, in the correct sequence. Refer to
on
206380-A
•
IRQ is the interrupt number used specifically for the BayStack 22
network card. This number must not be used by any other device in
the system. The default IRQ value is 3.
•
IOP is the starting input/output (I/O) port address, in hexidecimal
format. The BayStack 22 network card requires 32 consecutive free
I/O port addresses. The default IOP value is 0x300.
page B-4
for descriptions of these files.
Software Installation
"Client
Files"
3-37
Advertisement
Table of Contents
