Net Ipv6_Tunnel Isatap Add/Edit; Net Ipv6_Tunnel Isatap Delete <Row_Id; Net Ipv6_Tunnel Six_To_Four Configure - D-Link DSR-250 Cli Reference Manual

Unified Services Router
Sl No Command Name
5 wild_flag_enable
6 time_update_enable
7 cancel
8 exit
9 save

8.5 net ipv6_tunnel isatap add/edit

Sl No Command Name
1 end_point_type
2 ipv4_address
3 subnet_prefix
4 cancel
5 exit
6 save
8.6 net ipv6_tunnel isatap delete <row_id>
Sl No Command Name
1 row_id

8.7 net ipv6_tunnel six_to_four configure

Sl No Command Name
1 automatic_tunneling_enable
Description
Enable / Disable using wild cards
Set Timeperiod as 30 days
Roll back DDNS configuration changes
Save DDNS configuration changes and
exit current mode
Save DDNS configuration changes
Description
This is the endpoint address for the
tunnel that starts with this router. The
endpoint can be the LAN interface
(assuming the LAN is an IPv4 network),
or a specific LAN IPv4 address.
The local end point address if not the
LAN IPv4 address
This is the 64-bit subnet prefix that is
assigned to the logical
Roll back isatap tunnel configuration
changes.
Save isatap tunnel configuration
changes and exit current mode.
Save isatap tunnel configuration
changes.
Description
Row Id of the tunnel to be deleted
Description
Enable/disable automatic tunneling
which will allow traffic from an IPv6 LAN
to be tunneled through a IPv4 WAN to
reach an IPv6 network
23
CLI Reference Guide
Type and Description
Password.
Boolean (Y/N)
Wildcard flag
Boolean (Y/N)
Update for every 30 days or not
Type and Description
Local end point address type
(LAN/Other_IP),
IP Address
The local end point address
String, subnet prefix
Type and Description
Unsigned integer
Row id number
Type and Description
Boolean (Y/N)
Enable/ Disable automatic
tunneling