Navigation Setup - Kenwood DNX9140 Instruction Manual

Navigation Setup
You can set Navigation parameters.
D
Display 1:he Navigc.tion Setup screen
Touch [e]
> [,...] >
[Navigation]. (page 66)
D
Set each item
[NAV Intl:!rrupt Speaker] Selects speakers
used for voice guidance of the navigation
system.
([2]
"Front All")
"Front L": Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front 1\11": Uses both front speakers for voice
guidance.
[NAV Voice VOlUmE!] Adjusts the volume for
voice gJidance of the navigation system.
([2]
DNX9140: "25", DDX814/ DDX8034BT: "21 ")
[Line Mute] Mutes the volume during voice
guidance of the navigation system.
([2]
"Ot'J")
When turned "ON", the volume level drops for
voice g Jidance.
[Navigation Input] Selects a navigation
system connection.
([2]
"RGB") (DDX814/
DDX8034BT only)
"RGB": ;\lIows the Kenwood's Navigation
System to connect via its interface
cable.
"AV-IN": Allows a third-party navigation system
to connect via the AV INPUTl port.
"OFF": Must be used if no navigation system
is connected. (The navigation display
is cancelled when the AV source is
switched.)
[On Screen Navigation] Sets an on-screen
display of the navigation screen.
([2]
"OFF")
(DDX814/ DDX8034BT only)
"Auto": Information is displayed for 5 seconds
when updated.
"OFF": Information is not displayed.
English
J
79