Kenwood DNX9140 Instruction Manual page 112

Connection
Ignition key
switch
Jf\
If you connect the ignition wire (red) and the battery
~wire
(yellow) to the car chassis (ground), you may
cause a short circuit that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
ACC
A
B
A"-
Ignition wire (Red)
Car fuse box
Car fuse box
(Main fuse)
Battery wire (Yellow)
Ground wire (Black)
8
(To car chassis)
( iii
@=+'
1)==
Antenna Cord FM/AM
antenna input
Reveres sensor wire (Purple/White)
'-_----J
For the sake of safety, be sure to connect the parking sensor
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
Parking sensor wire (Light Green)
~
Connect to the vehicle's parking brake
~
detection switch harness
... Steering remote control input (Light Blue/Yellow)
To steering remote :
~.=====================
~
To use the steering wheel remote control feature, you need to
~
an exclusive remote adapter (not supplied) matches your car is
required. When this terminal is not in use, leave its cap on.
Dimmer control wire (OrangeIWhite)
To car light control switch
Connect to the terminal that is grounded when either : Mute wire (Brown)
the telephone rings or during conversation.
~=====================
~
To connect the Kenwood navigation system,
~
consult your navigation manual.
Depending on what antenna you are using, : Motor antenna control wire (Blue)
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
When using the optional power amplifier, : Power control wire (Blue/White)
connect to its power control terminal.
~
If no connections are made, do not let the cable come out from the tab.
4 I
DNX91401lDDX814/DDX8034BT