Navigation Setup - Kenwood DNX5260BT Instruction Manual

Navigation Setup

You can set Navigation parameters.
1 Display the Navigation Setup screen
>
Touch [ ] [
2 Set each item
[NAV Interrupt Speaker] Selects speakers
used for voice guidance of the navigation
system.
( "Front All")
"Front L": Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front All": Uses both front speakers for voice
guidance.
[NAV Voice Volume] Adjusts the volume for
voice guidance of the navigation system.
( DNX series: "25", DDX series: "21")
[NAV Mute] Mutes the volume during voice
guidance of the navigation system.
( "ON")
When turned "ON", the volume level drops for
voice guidance.
[Navigation Input] Selects a navigation
system connection.
( "RGB") (DDX series only)
"RGB": Allows the Kenwood's Navigation
System to connect via its interface
cable.
"AV-IN": Allows a third-party navigation system
to connect via the AV INPUT1 port.
"OFF": Must be used if no navigation system is
connected.
(The navigation display is cancelled
when the AV source is switched.)
>
] [Navigation]. (page 58)
[On Screen Navigation] Sets an on-screen
display of the navigation screen. (
(DDX series only)
"Auto": Information is displayed for 5 seconds
when updated.
"OFF": Information is not displayed.
⁄
• [On Screen Navigation]
It can be set only when [Navigation Input] is set to "AV-
IN".
"OFF")
English 71