Setting Reception Restriction - Kyocera TASKalfa 250ci Operation Manual

Setting Reception Restriction

You can restrict incoming faxes so that you only receive originals from senders registered in Permit FAX No.
and Permit ID No. and senders registered in your Address Book. This mode also allows you to set a [Reject List]
for Reception Restriction so that reception from senders on the list of Rejected FAX numbers or from senders
whose Local FAX Number is not registered are rejected. To change the reception restriction, follow the steps
below.
OPERATION GUIDE
3
To not use the sending restriction, press [Off]. To
restrict the other parties to which you send originals
only to the ones registered in Permit FAX No. and
Permit ID No. as well as the ones registered in the
Address Book, press [Permit List + Address Book].
4
Press [OK].
1
Press the System Menu key.
2
Press [FAX], [Next] of TX/RX Restriction, and then
[Change] of RX Restriction.
3
To not use the reception restriction, press [Off]. To
restrict the other parties from which you receive
originals only to the ones registered in Permit FAX
No. and Permit ID No. as well as the ones
registered in the Address Book, press [Permit List
+ Address Book]. To block incoming faxes from
senders registered in Reject FAX No., press
[Reject List].
4
Press [OK].
Setup and Registration
6-23
6