Turning The Appliance On; Turning The Appliance Off; Menu Settings; Descale - DeLonghi ECAM 23.420 Manual

TURNING THE APPLIANCE ON

Please note:
Before turning the appliance on, make sure the
main switch on the back of the appliance is in the
I position (fig. 1).
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which can-
not be interrupted.
The appliance is ready for use only after comple-
tion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of
the coffee spouts and is collected in the drip tray
underneath.
Avoid contact with splashes of water.
up... Please wait" is displayed.
After heating, the message "Rinsing..." is displa-
yed. As well as heating the boiler, the appliance
also heats the internal circuits by circulating hot
water.
The appliance is at temperature when a message
indicating the coffee taste and quantity is displa-
yed.

TURNING THE APPLIANCE OFF

Each time the appliance is turned off, it performs
an automatic rinse cycle which cannot be inter-
rupted.
Danger of burns!
During rinsing, a little hot water flows from the
coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the
(fig. 5). The appliance performs a rinse cycle,
displayed and the appliance goes off.
Please note:
If the appliance is not used for an extended pe-
riod, also place the main switch in the 0 position
(fig. 6).
Important!
To avoid damaging the appliance, never place the
main switch (fig. 6) in the 0 position while the
appliance is on.

MENU SETTINGS

When you access the programming menu by pressing
the P button, the following menu items are available:
Descale, Adjust time, Auto-off, Auto-start, Set tempe-
rature, Energy Saving, Water hardness, Set language,
Install filter, Replace filter, Beep, Default values, Stati-
stics.

Descale

For instructions on descaling, see page 16.

Adjust time

To adjust the time on the display, proceed as fol-
lows:
1. Press the P button to enter the menu;
2. Turn the selection knob (fig. 8) until "ADJUST
TIME" is displayed;
3. Press the
4. Turn the selection knob (fig. 8) to change the
hours;
5. Press the
6. Turn the selection knob (fig. 8) to change the
minutes;
7. Press the
This sets the time. Press the
the menu.

Auto-off (Stand by)

The appliance is set to turn off automatically if
not used for 2 hours.
The time can be changed so that the appliance
switches off after 15 or 30 minutes, or after 1,
2 or 3 hours.
1. Press the P button to enter the menu;
2. Turn the selection knob (fig. 8) until "Auto-
button
3. Press the
4. Turn the selection knob (fig. 8) until the de-
sired operation time is displayed (15 or 30
minutes, or 1, 2 or 3 hours);
5. Press the
6. Press the
Auto-off is programmed.
Please note:
To disconnect the appliance completely, place
the main switch at the back of the appliance in
the 0 position (fig. 6).
10
button (fig. 2);
button to confirm;
button to confirm.
button to exit
button;
button to confirm;
button to exit the menu.