Rs-232 Information - Runco Reflection CL-410 Owner's Operating Manual

Appendix: RS-232 Information
RS-232
Pin Configuration:
Pin 2: TxD
Pin 3: RxD
Pin 5: Ground
Communication:
Baud Rate: 9600
Bits: 8
Parity: None
Stop bits: 1
All commands are in ASCII format.
When the projector receives a valid code, it will reply with the first three letters of the
command followed by OK (example: If code RRA00 is sent, the projector will reply with
RRAOK). If the projector receives a non-valid command, no reply will be sent.
COMMAND
RRA00 Saves current settings to the CUSTOM 1 memory*
RRA01 Saves current settings to the ISF Day memory*
RRA02 Saves current settings to the ISF Night memory*
RRB00 Recalls the Custom 1 memory settings
RRB01 Recalls the ISF Day memory settings
RRB02 Recalls the ISF Night settings
RRC00 Selects the S-VIDEO input
RRC01 Selects the COMPOSITE VIDEO input
RRC02 Selects the COMPONENT 1 input
RRC03 Selects the COMPONENT 2 input
RRC04 Selects the DVI input
RRC05 Selects the RGB input
RRD00 Selects the ANAMORPHIC (16:9) aspect ratio
RRD01 Selects the STANDARD (4:3) aspect ratio
RRD02 Selects the LETTERBOX aspect ratio
RRD03 Selects the VIRTUALWIDE aspect ratio
RRD04 Selects the CINEMA (2.35:1) aspect ratio
RRD05 Selects the VIRTUAL CINEMA aspect ratio
RRE00 Turns the projector OFF
PON Turns the projector ON
*Note: All image quality settings must be made with the remote control. Once the
image adjustments are complete, these commands will allow the settings to be stored
in the selected memory.
**Note: The power on command (PON) will not provide an OK reply, it will instead
reply with a random character. For your automation system, simply ensure that you
receive a character after the PON command. If you do not get any reply after PON,
send PON again.
52
DESCRIPTION REPLY
RRAOK
RRAOK
RRAOK
RRBOK
RRBOK
RRBOK
RRCOK
RRCOK
RRCOK
RRCOK
RRCOK
RRCOK
RRDOK
RRDOK
RRDOK
RRDOK
RRDOK
RRDOK
RREOK
Random**