Programming A Device - Radio Shack 8-in-One Remote User Manual

8-

PROGRAMMING A DEVICE

The remote is preprogrammed at the factory to operate an RCA TV, VCR, and satellite
receiver, a Motorola (General Instruments) cable converter, and Pioneer CD and DVD
players, and audio devices. To control devices other than the default brands, perform the
following steps and repeat them as needed for each device to be programmed; otherwise
skip this section:
NOTE: To control a TV/VCR Combo, see "Programming A TV/VCR Combo" on page 18.
1. Find the codes for the devices you want to program in Manufacturer's Codes
(starting on page 84) and write them down or highlight them.
2. Turn on a device (e.g.,VCR or DVD player) and, if necessary, load media (e.g.,
cassette or disc).
NOTE: Please read steps 3 through 9 completely before proceeding. Highlight or write
down the codes and device you wish to program before starting step 2.
3. On the remote, press and hold P until the display changes from the default
device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown above.Your remote control
settings may be different.
NOTE: If you wish to exit the programming mode at any time, press EXIT once. An
[EXIT] message appears as the remote control returns to normal operation.
NOTE: If an [INVALID] message appears, you have inadvertently pressed an incorrect
key. Simply note your error and continue programming.
4. Press SELECT once to begin programming. The last-selected device and its
current code (e.g., TV and 0051) appear.
5. Press a desired device key once (e.g., VCR). The desired device and its current
code (e.g., VCR and 0035) appear.
NOTE: Use the AUX key to program home automation devices, video accessories, audio
services, and other audio/video devices. See "Reassigning Device Keys" on page 34.
6. Use the keypad to enter the first four-digit code for your device and press
SELECT once.
For example, to enter the first GE VCR code (on page 90), press 0 twice, 6 once,
0 once, and then SELECT once.
If the code is entered correctly, the [SUCCESS] message appears.
16 Programming A Device
-O R
IN NE EMOTE