Paper Jam In Finisher - Toshiba e-STUDIO160 Service Handbook

4.1.7 Paper jam in finisher

EA1 Finisher paper transport delay jam
Is there paper remaining on the transport path in the finisher or main unit?
YES
NO
Is the connector J10 on the finisher controller PWA disconnected?
Is the harness connecting the finisher controller PWA and inlet paper sensor broken?
YES
NO
Is the inlet paper sensor working properly? (Check the movement of the actuator.)
NO
YES
Replace the finisher controller PWA.
EA2 Finisher paper transport stop jam
Is there paper remaining on the transport path in the finisher or main unit?
YES
NO
Is the connector J10 on the finisher controller PWA disconnected?
Is the harness connecting the finisher controller PWA and inlet paper sensor broken?
YES
NO
Is the inlet paper sensor working properly? (Check the movement of the actuator.)
NO
YES
Replace the finisher controller PWA.
e-STUDIO160/200/250 TROUBLESHOOTING
Remove the paper.
Connect the connector securely. Replace the harness.
1. Connect the connector of the inlet paper sensor securely.
2. Attach the actuator securely if its shaft is out of place.
3. Replace the inlet paper sensor.
Remove the paper.
Connect the connector securely. Replace the harness.
1. Connect the connector of the inlet paper sensor securely.
2. Attach the actuator securely if its shaft is out of place.
3. Replace the inlet paper sensor.
4 - 26 December 2002 TOSHIBA TEC