Using Cisco Configuration Professional Express - Cisco 1900 series Hardware Installation

Performing the Initial Configuration on the Router
•
Use this configuration? {yes/no} : yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
%LINK-3-UPDOWN: Interface Ethernet0/1, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/0, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/1, changed state to down
%LINK-3-UPDOWN: Interface Serial0/2, changed state to down
%LINK-3-UPDOWN: Interface Serial1/0, changed state to up
%LINK-3-UPDOWN: Interface Serial1/1, changed state to down
%LINK-3-UPDOWN: Interface Serial1/2, changed state to down
<Additional messages omitted.>
When the messages stop appearing on your screen, press Return to get the Router> prompt.
Step 2
Note
%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found
The Router> prompt indicates that you are now at the command-line interface (CLI) and you have just
Step 3
completed a initial router configuration. Nevertheless, this is not a complete configuration. At this point,
you have two choices:
•
•

Using Cisco Configuration Professional Express

Use Cisco Configuration Professional Express web-based application to configure the initial router
settings. See the Cisco Configuration Professional Express User Guide document on Cisco.com for
detailed instructions,
http://www.cisco.com/en/US/docs/net_mgmt/cisco_configuration_professional_express/version1_1/on
line_help/CCPE11.pdf
For help with interface and port numbering, see the
Cisco 1900 Series Hardware Installation
6-8
If you answer yes, the configuration is saved, and you are returned to the user EXEC prompt
(Router>).
If you see the next message, it means that no other routers were found on the network attached
to the port.
Run the setup command facility again, and create another configuration.
Router> enable
Password: password
Router# setup
Modify the existing configuration or configure additional features by using the CLI:
Router> enable
Password: password
Router# configure terminal
Router(config)#
Chapter 6
"Interface Numbering" section on page
Configuring the Router
1-14.
OL-19084-02