Quick Start Guide 190 0 S ATA LY S T E R I E S A B L I N G A N D E T U P Catalyst 1900 Menu-based or command-line interface Serial cable 100BaseT 100BaseT Server Switch Crossover 10BaseT Hub cabling...
Page 3
Take Out What You Need Catalyst 1900 series switch Catalyst 1900 Series Quick Start Catalyst 1900 Series Installation and Configuration Guide RJ-45-to-RJ-45 rollover console cable Black AC power cable RJ-45-to-DB-9 serial connector RJ-45-to-DB-25 terminal connector Rack-mount kit Rubber feet Note: You need to supply Category 3, 4, or 5 straight-through or crossover UTP cables to...
Cable the Switch SERIES 10BaseT port (RJ-45) Category 5 straight-through cable 10BaseT port (RJ-45) Note: Use a straight-through cable to Connect to Switches and connect two ports when one of the ports is Hubs designated with an X. Use a crossover cable •...
9600 baud, 8 data bits, 1 stop bit, Note: You can use the internal power no parity, and no flow control. supply and/or the Cisco 600W AC Connect the supplied rollover cable to redundant power system (RPS). Attach only the CONSOLE port on the switch.
Page 6
Enter the [I] IP Configuration option from this logon screen. Enter the IP address of the switch at the prompt: Catalyst 1900 Management Console Copyright (c) Cisco Systems, Inc. Enter administrative IP address in 1993-1998 dotted quad format (nnn.nnn.nnn.nnn): All rights reserved.
Page 7
IP address. You can also use the web console to change the switch configuration and monitor network conditions and statistics. Note: The Catalyst 1900 Series Installation and Configuration Guide provides complete information about the web console and describes how to configure the switch.