Setting the Chassis on a Desktop
Figure 4-2
Setting the Chassis on a Desktop
You can place Cisco 1900 series routers on a desktop or shelf. The Cisco 1900 series router is shipped
with the rubber feet attached to the chassis to protect the desktop.
Warning
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed
to support the weight of the unit. Statement 1032
Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms). Excessive
Caution
weight on top of the router could damage the chassis.
Chassis Grounding
After the router has been installed, you must connect the chassis to a reliable earth ground. For the
chassis ground connection procedure, see the
page
Wall-Mounting the Chassis
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
Warning
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
The Cisco 1900 series router can be wall-mounted by using two number six, 3/4-inch screws and the
mounting features on the bottom of the router. You must provide the screws. We recommend using
pan-head or round-head screws.
The screws must go into a wall stud (wood) or a wall anchor of the appropriate type for the wall. Screws
Caution
into drywall are not sufficient to mount the router.
Cisco 1900 Series Hardware Installation
4-4
Cisco 1940 Series Chassis Airflow
4-10.
Chapter 4
DU RIN G
RE MO VE
DO NO T
AT IO N
K OP ER
NE TW OR
DU RIN G
RE MO VE
DO NO T
AT IO N
K OP ER
NE TW OR
"Installing the Chassis Ground Connection" section on
Installing and Connecting the Router
OL-19084-02