Uninstalling The Cisco Usb Driver; Uninstalling The Cisco Microsoft Windows Xp And 2000 Usb Driver; Uninstalling The Cisco Microsoft Windows Vista Usb Driver - Cisco 1900 series Hardware Installation

Connecting to a Console Terminal or Modem
If a User Account Control warning appears, click "Allow - I trust this program..." to proceed.
Note
The InstallShield Wizard Completed window appears. Click Finish.
Step 5
Connect the USB cable to the PC and router USB console ports. See
Step 6
LED for the USB console port turns green, and within a few moments a pop up window stating
"Installing device driver software" appears.
Step 7 The USB console is ready for use.

Uninstalling the Cisco USB Driver

Uninstalling the Cisco Microsoft Windows XP and 2000 USB Driver

This procedure shows how to uninstall both the Microsoft Windows XP and 2000 USB driver. The driver
can be removed using the Windows Add Remove Programs utility or the setup.exe program.
Using the Add Remove Programs utility
Disconnect the router console terminal before uninstalling the driver.
Note
Step 1 Click Start > Control Panel > Add or Remove Programs.
Step 2 Scroll to Cisco Virtual Com and click Remove.
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 3
Using the Setup.exe program
Disconnect the router console terminal before uninstalling the driver.
Note
Run the setup.exe program. Click Next.
Step 1
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 2
Step 3 When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 4 When the Remove the Program window appears, click Remove.
Step 5 When the InstallShield Wizard Completed window appears click Finish.

Uninstalling the Cisco Microsoft Windows Vista USB Driver

This procedure shows how to uninstall the Microsoft Windows Vista USB driver.
Cisco 1900 Series Hardware Installation
4-20
Chapter 4 Installing and Connecting the Router
Table 4-1 on page 4-17. The EN
OL-19084-02