Using The Cisco Cli—Manual Configuration - Cisco 1900 series Hardware Installation

Chapter 6 Configuring the Router
Using the Cisco CLI—Manual Configuration
This section shows you how to access the command-line interface (CLI) to perform the initial
configuration on the router.
If the system configuration dialog message does not appear, a default configuration file was installed on
the router prior to shipping. See the
page 6-8
For help with interface and port numbering, see the
Enter the following answer when the system message appears on the router.
Step 1
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return to terminate autoinstall and continue with manual configuration:
Step 2
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Press Return to bring up the Router> prompt.
Step 3
...
flashfs[4]: Initialization complete.
Router>
Type enable to enter privileged EXEC mode:
Step 4
Router> enable
Router#
•
•
•
•
•
•
•
•
•
•
•
OL-19084-02
to configure the router.
Configuring the Router Hostname, page 6-10
Configuring the Enable and Enable Secret Passwords, page 6-11
Configuring the Console Idle Privileged EXEC Timeout, page 6-12
Configuring Gigabit Ethernet Interfaces, page 6-14
Specifying a Default Route or Gateway of Last Resort, page 6-16
Configuring IP Routing and IP Protocols, page 6-16
Configuring Virtual Terminal Lines for Remote Console Access, page 6-19
Configuring the Auxiliary Line, page 6-20
Verifying Network Connectivity, page 6-22
Saving Your Router Configuration, page 6-23
Saving Backup Copies of Configuration and System Image, page 6-23
Performing the Initial Configuration on the Router
"Using Cisco Configuration Professional Express" section on
"Interface Numbering" section on page
(Optional)
(Required)
(Required)
(Optional)
(Required)
(Required)
Cisco 1900 Series Hardware Installation
1-14.
(Required)
(Optional)
(Required)
(Required)
(Optional)
6-9