EPSON Stylus CX3500/CX3600/CX3650/CX4500/CX4600
V External View (3)
C.B.P (P1) 1.7x5 F/ZB
PW Sensor Cap
(2±0.5kgfcm)
Notch
Hooks
Connector
Figure 4-41. Carriage Unit Removal (3)
DISASSEMBLY AND ASSEMBLY
PW Sensor Board
Connector
Head FFC
Notch
Disassembly
T
PW Sensor Board Removal
1.
Remove the screw (x1,
) for securing PW Sensor Cap, and then remove
PW Sensor Cap.
2.
Disconnect Head FFC from the connector of PW Sensor Board, and then pull
out Head FFC from the notch of Carriage.
Do not allow PW Sensor Cap to float.
T
Head FFC Removal
1.
Remove Print Head from Carriage Unit.
2.
Pull out Head FFC from the notch of Carriage.
3.
Release Head FFC from the hooks (x4,
4.
Disconnect Head FFC from the connector of CSIC board.
After changing the Carriage Unit for a new one, always apply
A D J U S T M E N T
R E Q U I R E D
grease KEN to the specified portions.
T
Refer to Chapter 6,
When having replaced Carriage Unit, implement the adjustment in
A D J U S T M E N T
R E Q U I R E D
the following order. (Refer to Chapter 5 "ADJUSTMENT")
1.
PG Adjustment
2.
Top margin adjustment
3.
Head angular adjustment
4.
Bi-D adjustment
5.
PW adjustment
6.
First dot adjustment
Revision A
) for securing Head FFC.
Figure 6-7 (p.178)
151