Cap/Wipe/Purge Assembly (Phaser 850/860 Printer); Removing The Lower Cap/Wipe/Purge Retainer Clip - Xerox Phaser 840 Service Manual

Cap/wipe/purge assembly (Phaser 850/860 printer)

Even when the printer is turned off, AC line voltages may be
Warning
present at the printer heaters while the printer is plugged into AC
power.
Turn off the printer and remove the power cord.
1.
Remove the right cover.
1.
Remove the left cover.
2.
Disconnect the head-tilt spring.
3.
Remove the top cover.
4.
Remove the ink loader.
5.
Remove the metal heat duct over the printhead.
6.
Tilt back the printhead and center it.
7.
Remove the maintenance drawer.
8.
Remove the right maintenance drawer guide.
9.
Right
maintenance
drawer guide
Fig 7-21 Removing the lower cap/wipe/purge retainer clip
Disconnect the wiring harness leading from the cap/wipe/purge assembly to the power
10.
supply wiring harness. Clip the tie wraps securing the cap/wipe/purge wiring harness.
Disconnect the green ground wire from the printer frame.
From within the maintenance drawer cavity, remove the lower white retainer clip at the
11.
lower-right end of the cap/wipe/purge assembly.
7 - 204 Phaser 840/850/860/8200 Color Printer - Service Manual
840-4-80