Xerox Phaser 840 Service Manual page 222

Remove the guide rod connecting the bottom of the cap/wipe/purge assembly to the
14.
grooves in the printer frame.
Remove the white retainer clip at the upper-left end of the cap/wipe/purge assembly
15.
Remove the metal vacuum tube from the vacuum inlet of the assembly.
16.
While holding onto the cap/wipe/purge assembly, remove the guide pin that holds the
17.
cap/wipe/purge assembly in place.
Push the wiring through the print engine's frame so that you can free the
18.
cap/wipe/purge assembly.
Reverse these steps to reinstall the cap/wipe/purge assembly. Refer to "Wiring Diagrams",
on page 9-235 for details on dressing the cap/wipe/purge wiring.
Vacuum
tube
Guide
rod
Fig 7-23 Removing the cap/wipe/purge assembly (Phaser 850/860
printer)
7 - 206 Phaser 840/850/860/8200 Color Printer - Service Manual
Vacuum
inlet
Cap wipe/purge
assembly
Plastic
retainer
clip
Guide
pin
840-4-82