Audio Board - HP EliteBook 2760p Maintenance And Service Manual

h. Remove the Bluetooth module (see
i. Latch assembly (see
Remove the speaker assembly:
1. Position the computer right-side up, with the front toward you.
2. Unplug the speaker cable (1) from the audio connector board, and note the routing channel of
the speaker cable in the base enclosure.
3. Slide the the speakers and cables (2) from the base enclosure and lift to remove.
Reverse this procedure to install the speaker assembly.

Audio board

Description
Audio connector board
Before removing the audio connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Remove the battery (see
b. Remove the service access cover (see
72 Chapter 4 Removal and replacement procedures
Bluetooth module on page
Latch assembly on page
Battery on page 41)
Service access cover on page
68)
70)
Spare part number
649762-001
42)