HP EliteBook 2760p Maintenance And Service Manual page 58

Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module and
disengage them from the channels (2) holding them in place.
NOTE:
The white WLAN antenna cable is connected to the WLAN module "Aux" terminal.
2. Remove the two Phillips M2.5×3.0 screws (3) that secure the WLAN module to the computer.
3. Remove the WLAN module by pulling the module away from the slot at an angle (4).
NOTE:
Reverse this procedure to install the WLAN module.
50 Chapter 4 Removal and replacement procedures
The black WLAN antenna cable is connected to the WLAN module "Main" terminal.
WLAN modules are designed with a notch (5) to prevent incorrect insertion.