Smart Card Reader - HP EliteBook 2760p Maintenance And Service Manual

Smart card reader

Description
Smart card reader
Before removing the smart card reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Remove the battery (see
b. Remove the service access cover (see
c. Remove the WLAN module (see
d. Remove the WWAN module (see
e. Remove the keyboard (see
f. Remove the top cover (see
g. Remove the display assembly (see
h. System board shield (see
Remove the smart card reader:
1. Position the computer right-side up, with the front toward you.
2. Disconnect the smart card reader cable from the ZIF connector (1) on the system board and
remove the cable (2).
74 Chapter 4 Removal and replacement procedures
Battery on page 41)
Service access cover on page
WLAN module on page
WWAN module on page
Keyboard on page 53)
Top cover on page 57)
Display assembly on page
System board shield on page
Spare part number
597839-001
42)
48)
51)
63)
66)