If You Replace The Head/Carriage Unit Or Engine Unit; Load The Full Maintenance Program Temporarily (Required For The Mfc210C U.s.a./Canadian Models) - Brother MFC620CN Service Manual

6.2 IF YOU REPLACE THE HEAD/CARRIAGE UNIT
OR ENGINE UNIT
[ 1 ] Load the full maintenance program temporarily (Required for the MFC210C U.S.A./Canadian
models)
NOTE: Before proceeding the program loading procedure, install the printer driver to the work PC.
(Refer to Appendix
NOTE: The full maintenance program file (LZ****.
the work PC beforehand.
(1) Make sure that the machine's power cord is unplugged from an electrical outlet.
If the machine is connected to a PC, unplug the USB cable.
(2) Switch on the work PC.
(3) While holding down the 5 key, plug the machine's power cord into an electrical outlet.
NOTE: This step is not required if the main PCB is replaced with a new one. Just turning on
the machine automatically switches to program loading.
(4) Connect the machine to the work PC using the USB cable.
(5) Run "FILEDG32.exe" in the folder created.
The Filedrgs window appears as shown below.
(6) Drag and drop the full maintenance program icon onto the BHL2-Maintenance Printer icon in
the Filedrgs window shown above.
When the work PC starts loading the full maintenance program to the flash ROM in the
machine, the machine beeps intermittently.
Loading terminates in approx. one minute. Before the machine automatically switches to
standby, disconnect the USB cable.
2.)
) should be saved in an arbitrary folder in
upd
6 - 7 Confidential