Remove Crankshaft; Remove Governor Cross Shaft; Remove Flywheel End Oil Seal; Removing Oil Seal - Kohler CH18-745 Service Manual

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 9
Disassembly

Remove Crankshaft

1. Carefully pull the crankshaft from the crankcase.
See Figure 9-68. Note thrust washers and shims
if used.
Figure 9-68. Removing Crankshaft.

Remove Governor Cross Shaft

1. Remove the hitch pin and plain washer, or the
retainer and nylon washer, from the governor
cross shaft. See Figures 9-69 and 9-70.
Figure 9-69. Removing Governor Cross Shaft Hitch
Pin (6 mm Shaft Design).
9.18
Figure 9-70. Removing Governor Cross Shaft
Retainer (8 mm Shaft Design).
2. Pull the cross shaft with small washer out through
the inside of the crankcase. See Figure 9-71.
Figure 9-71. Pulling Governor Cross Shaft.

Remove Flywheel End Oil Seal

1. Remove oil seal from crankcase. See Figure
9-72.
Figure 9-72. Removing Oil Seal.
www.mymowerparts.com