Remove Carburetor; Remove External Governor Controls; Rear Air Cleaner Bracket; Disconnecting Spring From Bracket - Kohler CH18-745 Service Manual

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 9
Disassembly
Figure 9-19. Rear Air Cleaner Bracket (Some
Models).
2. Mark the spring hole locations and disconnect the
spring from the governor lever. See Figure 9-20.
Figure 9-20. Disconnecting Spring from Bracket.
3. Remove the choke linkage from the choke
actuator lever and carburetor. See Figure 9-21.
Figure 9-21. Disconnecting Choke Linkage from
Actuator Lever.
9.6

Remove External Governor Controls

1. Loosen the hex. flange nut and remove the
governor lever from the cross shaft. See Figure
9-22. Leave lever attached to the throttle linkage
and lay assembly on the top of the crankcase.
Figure 9-22. Removing Governor Lever.

Remove Carburetor

Gasoline is extremely flammable and its vapors can
explode if ignited. Store gasoline only in approved
containers, in well ventilated, unoccupied buildings,
away from sparks or flames. Do not fill the fuel tank
while the engine is hot or running, since spilled fuel
could ignite if it comes in contact with hot parts or
sparks from ignition. Do not start the engine near
spilled fuel. Never use gasoline as a cleaning agent.
1. Disconnect the fuel shut-off solenoid lead if so
equipped.
2. Remove the two carburetor mounting screws. See
Figure 9-23.
Figure 9-23. Removing Carburetor Mounting
Screws.
www.mymowerparts.com
WARNING: Explosive Fuel!