Remove B+ Lead From Terminal Plug; Note Location Of Two Short Screws; Removing Outer Baffles; Removing The Spark Advance Module - Kohler CH18-745 Service Manual

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 9
Disassembly
Figure 9-28. Remove B+ Lead from Terminal Plug.
3. The rectifier-regulator does not have to be
detached from the blower housing. If the engine is
equipped with SMART-SPARK
should be removed from the cylinder baffle or
blower housing. See Figure 9-29. The module
willing hang loose as part of the wiring harness.
Figure 9-29. Removing the Spark Advance Module
(Applicable Models).
9.8
4. Remove the three (each side) hex. flange screws
the SAM module
™
Figure 9-30. Note Location of Two Short Screws.
Figure 9-31. Removing Outer Baffles.
5. Remove the outer baffles on both sides. See
6. On engines equipped with a metal grass screen,
www.mymowerparts.com
securing the outer baffles. Note the location of
any lifting strap and position of the two short
screws (one each side on bottom) for reassembly.
See Figure 9-30.
Figure 9-31.
remove the screen before removing the blower
housing. See Figure 9-32. Plastic grass screens
can be removed after the blower housing is
removed.