Kohler COMMAND CV17-745 Service Manual page 54

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 5
Fuel System and Governor
Choke Lever Detail
Choke Lever
Screw
Washer
Spring Washer
Lock
Spacer
Nut
Bushing
Linkage
Blower Housing
Figure 5-38. Governor Used with Commercial Mower Air Cleaner.
Commercial Mower Governor
Arrangement
The Commercial Mower governor arrangement shown
in Figure 5-38 is used primarily on wide area walk
behind mower applications. The initial adjustment and
sensitivity adjustment is the same as for the standard
governor. Should the governor spring be disconnected
from the throttle lever and governor lever, reconnect it
as follows:
5.20
Choke Cable
Control
Bracket
Washer
Spring
Clip
Lever
Spring
www.mymowerparts.com
Fastener
Choke Lever
(See Detail at Left)
Screw and Nut
Control Lever
Lock Nut
Washer
Locker Nut
Throttle Lever
1. Hook the long end of the spring through the hole
in the lever from the left side.
2. Rotate the spring 180° until hooked as shown in
Figure 5-38.
3. Hook the short end of the spring into the
appropriate hole in the governor lever. Refer to
the appropriate chart in Section 11 -
"Reassembly" of this manual for the correct hole
to use for the speed involved.
Fastener
Throttle
Clamp
Cable
Fuel
Pump
Clamp
Bushing
Fuel Line
Spring
Linkage
Bushing
Throttle Shaft
Bracket
Deflector
(If So Equipped)
Spacer
(Place Between
Valley Baffle
and Throttle
Shaft Bracket)