Kohler COMMAND CV17-745 Service Manual page 154

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 9
Disassembly
2. Locate the splitting tabs cast into the perimeter of
the oil pan. Insert the drive end of a 1/2" breaker
bar between the splitting tab and the crankcase
and turn it to break the RTV seal. See Figure
9-49. Do not pry on the sealing surfaces as this
can cause leaks.
Governor Gear Assembly
The governor gear assembly is located inside the oil
pan. If service is required, refer to the service
procedures under "Governor Gear Assembly" in
Section 10.
Oil Pump Assembly
The oil pump is mounted inside the oil pan. If service is
required, refer to the service procedures under "Oil
Pump Assembly" in Section 10.
Remove Camshaft
1. Remove the camshaft and shim. See Figure 9-50.
Figure 9-50. Removing Camshaft.
Remove Governor Cross Shaft
1. Remove the hitch pin and plain washer, or the
retainer and nylon washer, from the governor
cross shaft. See Figures 9-51 and 9-52.
9.14
Figure 9-51. Removing Governor Cross Shaft Hitch
Pin (6 mm Shaft Design).
Figure 9-52. Removing Governor Cross Shaft
Retainer (8 mm Shaft Design).
2. Remove the cross shaft through the inside of the
crankcase. See Figure 9-53.
Figure 9-53. Removing Governor Cross Shaft.
www.mymowerparts.com