Kohler COMMAND CV17-745 Service Manual page 186

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 11
Reassembly
Figure 11-54. Installing Screws (Locations 3 and 4).
4. Install the inner baffles using the remaining two
hex. flange screws (see Figures 11-55 and 11-56)
and finger tighten. Do not torque the screws at this
time; they will be tightened after the blower housing
and outer baffles are installed.
Figure 11-55. Installing Inner Baffles.
Figure 11-56. Finger Tighten Two Remaining Cover
Screws.
11.16
Install Blower Housing and Outer Baffles
NOTE: Do not completely tighten screws until all
1. Pull the wire harness and spark plug leads out
through the appropriate openings in the
shrouding. See Figures 11-57 and 11-58.
Figure 11-57. Wires on Starter Side of Engine.
Figure 11-58. Wires on Oil Filter Side of Engine.
2. Slide the blower housing into position over the
front edge of the inner baffles. See Figure 11-59.
Start a few of the screws to hold it in place.
www.mymowerparts.com
items are installed to allow shifting for hole
alignment.